710870-1 F-LOW 60K Waterjet Cutting Head

Descripción

710870-1 F-LOW 60K Waterjet Cutting Head

710870-1 F-LOW 60K Waterjet Cutting Head Assembly produced by WINWIN Waterjet is of high quality. Welcome to the WINWIN Waterjet.

  Waterjet cutting systems typically use two types of cutting head: pure waterjet cutting head  and abrasive waterjet cutting head  .

Pure waterjet cutting head  : These cutting heads are used when cutting softer materials such as foam, rubber, or certain types of plastics where abrasive particles are not required. Pure waterjet cutting heads have a small orifice that focuses a high-pressure stream of water onto the material, generating a cutting force through sheer pressure. These cutting heads are typically made of materials that can withstand the high-pressure water flow.

Abrasive waterjet cutting head  : Abrasive cutting heads are used when cutting harder materials such as metal, stone, glass, or composites. These cutting heads have a similar design to pure waterjet cutting head but also have an additional mixing chamber where abrasive particles are introduced into the waterjet stream. The abrasive particles, such as garnet, are mixed with the high-pressure water and accelerate to high speeds, enhancing the cutting ability of the waterjet. Abrasive waterjet cutting heads are typically made of materials that can withstand the abrasive wear caused by the particles.

Both types of cutting heads are available in various sizes and configurations to accommodate different cutting requirements. The selection of the cutting heads depends on factors such as the material being cut, the desired cutting speed, and the precision needed for the application. Manufacturers of waterjet cutting systems often provide a range of cutting heads options to suit different materials and cutting conditions.

If you are interested in 710870-1 F-LOW 60K Waterjet Cutting Head,you can contact us for price list.